Application & Care

How to Apply Stickers and Care for Shirts/Cups/Ornaments


  1. Clean the area you will apply the sticker thoroughly with rubbing alcohol or soap and water. Dry it thoroughly.
  2. Prepare the sticker for application by firmly rubbing a squeegee or credit card across the transfer tape. 
  3. Peel the paper backing off the sticker with the Transfer Tape side facing down, pulling the Paper Backing off the Transfer tape. If the sticker clings to the backing, slowly replace the backing and repeat Step 2.
  4. Slowly lower the sticker onto the surface and rub it in place firmly with a squeegee or credit card from the center outward to remove any bubbles and make sure you have firm adhesion. 
  5. Slowly peel the transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.

Vinyl Shirt Care and Handling Instructions 

  1. Wash Cold Inside Out! While your New Shirt can be washed in Warm Water, We recommend that you turn it inside out and wash on Cold to keep your Shirt looking Awesome for a Long time!
  2. Tumble Dry LOW or Hang Dry. Our Shirts can be dried in the dryer, just keep the temperature low.  We ultimately recommend Hang Dry and then toss in the dryer for a few min on low or medium to soften it back up! 
  3. When washing do not use Bleach or harsh chemicals. Bleach can ruin vinyl.  If you must get out stains, we recommend Spot Treating the area with a stain remover. 
  4. Do NOT Wash your shirt for at least 48 hours after we have pressed it. This ensures that your shirt is fully set and won’t get ruined in the wash.  You CAN wear your Shirt Immediately.
  5. If you have any questions or concerns contact us immediately. We will respond to any questions ASAP.  emailphoenixrising@gmail.com
Epoxy Tumbler Cup Care & Washing Instructions
  1. HAND WASH Only! Do not Place customized part of cup/tumbler/water bottles in the Dishwasher.  The Heat can cause damage to glitter and epoxy.  Lids and Straws are perfectly fine to put in the dishwasher.
  2. DO NOT MICROWAVE. Cups/Tumblers/Water Bottles are made of METAL. 
  3. When hand washing do not use Steel Wool or any abrasive on the epoxy. While it is hardened resin, it can still be scratched by steel wool or sandpaper on the outside.  You can use any regular sponge or scrubby brush to clean your cups.
  4. When you receive your new cup/tumbler/water bottle from us, PLEASE wash it first before using. We do hand wash each cup before shipping, but we always recommend an additional quick wash before first use just to be safe.
  5. If you have any questions or concerns contact us immediately. We will respond to any questions ASAP.  emailphoenixrising@gmail.com


Continue